Our Raspberry Pi Plus range of expansion boards are designed using the HAT mechanical specification to ensure maximum compatibility with third party Raspberry Pi HAT boards which can be stacked above our expansion boards using the optional four post mounting kits.
All of our Raspberry Pi Plus expansion boards and adapter kits are compatible with the Raspberry Pi A+, B+, Raspberry Pi 2 Model B, Raspberry Pi 3 Model B and Pi Zero and can be stacked to mix and match your requirements so you could add analogue inputs, up to 128 extra input / output ports, serial RS232 communications or a real time clock module. You can also mix our Raspberry Pi Plus boards with our expansion boards for the Raspberry Pi model A and B range which use the first 26 GPIO pins on the stackable headers.
1 Wire interface for the Raspberry Pi
1 Wire interface for the Raspberry Pi Zero
8 Channel 18 bit Analogue to Digital converter for the Raspberry Pi
8 Channel Analogue to Digital converter for the Raspberry Pi
2 Channel ADC and 2 Channel DAC for the Raspberry Pi Zero, 1A, 1B, 2, and 3
Prototyping board for Raspberry Pi + and 2
Prototyping board for Raspberry Pi Zero
Expansion interface for the Raspberry Pi
Suitable for the Raspberry Pi B+ GPIO port
32 channel I/O expander for the Raspberry Pi
16 channel I/O expander for the Raspberry Pi Zero
Raspberry Pi Plus Breakout Kit for the Raspberry Pi
RS485 interface for the Raspberry Pi
Real-time clock for the Raspberry Pi
RS232 serial interface for the Raspberry Pi+ and Raspberry Pi 2
RS232 serial interface for the Raspberry Pi Zero
16-channel, 12-bit PWM controller for driving LEDs and RC servos.
Mounting kit to use on our Raspberry Pi + and 2 boards
Raspberry Pi HAT vs AB Electronics UK expansion boards comparison:
The Raspberry B+ model was released on the 14th August 2014 and has a redesigned PCB compared to the older model A and B. The new B+ has an extra two USB ports and the 26 pin GPIO port has been replaced with a new 40 pin GPIO port which has extra I/O pins and support for a rom chip on non-stackable expansion boards called ‘HATs’ (Hardware Attached on Top).
In November 2014 the Raspberry Pi A+ was released as a low power alternative to the B+. The A+ does not include ethernet, only has one USB port and is smaller than the B+.
In Febuary 2015 the Raspberry Pi 2 Model B was released to replace the previous model B+, the new Raspberry Pi 2 Model B has a faster 900MHz quad-core ARM Cortex-A7 CPU and 1 GB Ram.