No i2c detected
The 1 Wire Pi Plus and 1 Wire Pi Zero are a 1 Wire interface for the Raspberry Pi
17/08/2017
Posted by:
dkjellqu
17/08/2017
Posted by:
andrew
The most common cause for no device showing up is the device is not being powered correctly. When you assembled the 1 Wire Pi Plus did you fit the jumper to the two holes next to the R2 multiway resistor above the AD1 jumper? If you have access to a multimeter could you check the 5V and GND on the row of pins next to the RJ12 connector to make sure there is 5V present on the board? It may also be worth checking the GPIO connector and the RJ12 connector carefully to make sure there are no bridges or dry joints.
17/08/2017
Posted by:
dkjellqu
Forum Notice – Closure to New Posts
As part of our compliance with the UK’s Online Safety Act, the AB Electronics UK support forum is now closed to new posts and replies.
We understand the importance of continued support for our products, so if you have a technical query or require assistance, please use the Contact Form or consult our Knowledge Base for helpful articles and documentation.
We appreciate your understanding and continued support.
Note: documents in Portable Document Format (PDF) require Adobe Acrobat Reader 5.0 or higher to view.
Download Adobe Acrobat Reader or other PDF reading software for your computer or mobile device.
