Multiple 1 Wire Pi Plus boards
The 1 Wire Pi Plus and 1 Wire Pi Zero are a 1 Wire interface for the Raspberry Pi
02/09/2016
Posted by:
pavelbor
Hello,is it possible to have 2 "1 Wire Pi Plus" boards (of cource, with different i2c addresses) installed on Raspberry Pi?For example, for connection 2 separate 1-wire networks into one owfs ?
02/09/2016
Posted by:
andrew
HelloYou can stack two 1 Wire Plus boards on a Raspberry Pi. OWFS will detect both of the boards and allow you to connect to devices on both 1 Wire networks.The only issue you may find with stacking two of the boards directly on top of each other is the plastic tabs on the RJ12 socket protrude out of the bottom of the board and will make them too tall to use our mounting kits properly. One solution to that would be to trim the tabs off of the connector to reduce its height but this will mean it is not secured to the PCB so you may need to add a bit of glue to keep it from coming loose.
Forum Notice – Closure to New Posts
As part of our compliance with the UK’s Online Safety Act, the AB Electronics UK support forum is now closed to new posts and replies.
We understand the importance of continued support for our products, so if you have a technical query or require assistance, please use the Contact Form or consult our Knowledge Base for helpful articles and documentation.
We appreciate your understanding and continued support.
Note: documents in Portable Document Format (PDF) require Adobe Acrobat Reader 5.0 or higher to view.
Download Adobe Acrobat Reader or other PDF reading software for your computer or mobile device.
