Can i2c operate in Slave Mode?
The 1 Wire Pi Plus and 1 Wire Pi Zero are a 1 Wire interface for the Raspberry Pi
16/01/2023
Posted by:
seanbolton
I want to be able to configure a Raspberry Pi device as an i2c slave device.
Is this possible with any of the abel electronics I2C add on modules?
Sean
16/01/2023
Posted by:
andrew
As far as I am aware, it is not possible to configure a Raspberry Pi as an I2C slave device, and none of our add-on modules would allow you to do this.
16/01/2023
Posted by:
seanbolton
I did find an example project for the Raspberry Pi Pico board which enables slave mode.
https://pypi.org/project/picoslave/
I haven't tried it yet but from the description it looks like it will support i2c slave mode.
I am not sure if this is for the Pi Pico only and not possible on other Pi's e.g. Pi 4.
regards
Sean
16/01/2023
Posted by:
andrew
Forum Notice – Closure to New Posts
As part of our compliance with the UK’s Online Safety Act, the AB Electronics UK support forum is now closed to new posts and replies.
We understand the importance of continued support for our products, so if you have a technical query or require assistance, please use the Contact Form or consult our Knowledge Base for helpful articles and documentation.
We appreciate your understanding and continued support.
Note: documents in Portable Document Format (PDF) require Adobe Acrobat Reader 5.0 or higher to view.
Download Adobe Acrobat Reader or other PDF reading software for your computer or mobile device.
